FitmentSpec Logo
Nissan logo
2nd & 3rd Gen J11/J12 (Visia / Acenta / N-Connecta / Tekna / Tekna+ / Rogue Sport) (2014–2026)

2016 Nissan Qashqai

Wheel fitment, bolt pattern, TPMS calibration, and factory engineering specifications.

2016 Nissan Qashqai
Factory Powertrain 1.3L DIG-T Mild Hybrid / 1.5L e-POWER
156 HP (116 kW) 192 lb-ft 1.3L Inline-4
Chassis Dimensions Exterior & Curb Weight
L: 174.2" W: 72.2" WB: 105" 2,987 – 3,556 lbs lbs
Center BoreHub Centric
66.1 mm
Hub Ring Spigot Diameter
Offset RangeET
+35 to +45
Flush Target: ET +35
Lug TorqueM12x1.25
83 ft-lbs
113 Nm • Conical Seat
Fastener: Conical 60deg Lug Nut. Always re-torque after 50–100 miles of driving.Get Torque Wrench→
⚠️
Mandatory Verification Notice: Bolt patterns, hub tolerances, and torque values vary by factory brake option and trim. Always verify specs with your vehicle's driver door-jamb safety placard or a certified mechanic prior to mounting wheels. Use of this data is strictly at your own risk. Read Full Legal Disclaimer →
⚓

2016 Nissan Qashqai Towing Capacity & Hitch Telemetry

Official manufacturer braked tow ratings, max tongue weight, and payload limits.

Certified Tow Rating: 3,968 lbs
Max Towing (Braked)
3,968 lbs
1,800 kg
With factory trailer brakes
Max Payload Capacity
1,100 lbs
499 kg
Cabin + bed passenger load
Max Tongue Weight (10%)
397 lbs
180 kg
Maximum hitch downward load
Hitch Receiver Class
Class III (2-inch Receiver)
Standard bumper / ball mount
🚛 Can It Tow? Real-World Trailer Capability Matcher
Click any trailer type to test compatibility against 2016 Qashqai
Selected Load: 3,968 lbs • Vehicle Rating: 3,968 lbs
At Maximum Limit (Caution)
📋 Factory Towing Guidance:

Adhere to factory towing manual limits and trailer tongue weight balance.

⚙️ Essential Towing Safety Guidelines:
  • • Unbraked trailer maximum limit: 1389 lbs (630 kg).
  • • Trailer brakes mandatory for loads exceeding 3,000 lbs in most jurisdictions.
  • • Maintain tongue weight between 10%–15% of total gross trailer weight (GTW) to prevent dangerous trailer sway.

2016 Nissan Qashqai Quick Fitment Answers

Looking for exact hub and wheel specifications for the 2016 Nissan Qashqai? The factory bolt pattern is 5x114.3 (5-lug) with a 66.1 mm center bore. The manufacturer specified wheel lug torque is 83 ft-lbs (113 Nm) using M12x1.25 Lug Nuts with a Conical 60deg seating surface. Safe wheel offset range is +35mm to +45mm.

Factory OEM Wheel & Tire Configurations (2016)

3 TRIM OPTIONS
Trim Name Wheel Size Tire Specification Placard PSI Equipment
17" Visia / Acenta / S Alloy 17x7 ET+40
215/60R17 Compare ⚡
33 / 30 PSI Find Tires →
18" N-Connecta / SV Alloy 18x7.5 ET+40
215/55R18 Compare ⚡
33 / 30 PSI Find Tires →
19" Tekna / Tekna+ / SL Diamond Cut Alloy 19x7.5 ET+40
225/45R19 Compare ⚡
35 / 32 PSI Find Tires →

🔧 Technical Service Bulletins (TSB) & Suspension Chronic Issues

1 DOCUMENTED ISSUES
Front Suspension Strut Bearings & Lower Control Arms Low Severity
Symptom

Creaking noise over speed humps or when turning steering wheel at low parking speeds

Root Cause & TSB Details

Premature wear in front upper strut mount axial bearings and lower control arm rear hydro-bushings (NTB18-052)

Affected Components: Strut Mount Axial BearingsLower Control Arm Compliance BushingsFront Sway Bar Drop Links
⭕

Hub Centric Ring Finder & Vibration Eliminator

Precision adapter sizing for Nissan Qashqai factory 66.1 mm hub snout.

Factory Hub: 66.1mm
Hub Diagnostic Result
✅ HUB CENTRIC RINGS REQUIRED

The wheel bore is +7.0 mm larger than the vehicle hub. To prevent steering wheel wobble at 50–75 mph, install this exact ring set:

73.1mm to 66.1mm (OD: 73.1mm / ID: 66.1mm)
🛒 Order 73.1mm to 66.1mm Ring Set on Amazon↗
💡 Pro Tip: Aluminum billet rings are recommended for track / high brake heat; polycarbonate plastic rings are ideal for salt & winter weather.
📐

OEM vs. Aftermarket Visual Stance & Poke Gauge

Simulate fender lip clearance (Poke) and inner suspension strut clearance in real time.

Stock Baseline: 7" ET40
New Wheel Width:8.0" (+1.0" vs OEM)
New Wheel Offset (ET):ET30 mm (-10mm vs OEM)
Wheel Spacer (Optional):+0 mm
Stance & Clearance Breakdown🔥 WIDE POKE
Outer Lip (Fender Poke)
+22.7mm
Extends outward toward fender
Inner Lip (Strut Room)
-2.7mm
Closer to suspension strut
FENDER LIPHUB FACE
Inner Strut SideOuter Wheel Face
📋

Printable Mechanic Spec Card & Torque Sequence

High-contrast pocket card for tire shops, track days, and garage toolboxes.

5x114.3
2014-2026 FITMENT SPECIFICATION

2016 Nissan Qashqai

fitmentspec.com/nissan/qashqai/2016
FINAL TORQUE83 ft-lbs(113 Nm)
Bolt Pattern (PCD)5x114.3
Center Bore66.1 mm
Fastener & ThreadM12x1.25Lug Nut • Conical 60deg
TPMS CalibrationDirectDoor Placard PSI
⭐ TORQUE SEQUENCE:Always torque in a star (criss-cross) pattern in 2 stages: 50% initial hand snug, 100% with calibrated torque wrench.
⚠️ NEVER USE IMPACT GUN FOR FINAL TORQUE

⚡ Will It Rub? 2D Offset & Strut Clearance

Real-time inner strut clearance and outer fender poke calculation.

CAUTION: Tight clearance. May contact fender under full suspension travel.
OEM Baseline18x8 ET+50
Rim Width: 8"Offset: +50mm
Target Custom Spec18x8.5 ET+40
Rim Width: 8.5"Offset: +40mm
Inner Strut Shift
-3.7 mm
More inner room
Fender Poke Shift
+16.3 mm
Extends outward
▲ Recalibrate RequiredDiameter: +5.55" (+20.44%)
+20.44%
Original Baseline Tire215/60R17
New Target Tire285/70R17
QUICK SIZES:
27.2"32.7"
Speedometer Variance Table
30 mph gauge36.1 actual+6.1 mph
45 mph gauge54.2 actual+9.2 mph
60 mph gauge72.3 actual+12.3 mph
70 mph gauge84.3 actual+14.3 mph
80 mph gauge96.4 actual+16.4 mph
❄️

WINTER WHEEL & MINUS-SIZING ADVISOR

Optimal cold-weather setup for maximum snow bite, pothole cushion, and rim protection.

OPTIMAL WINTER SPEC
205/65R16
Mounted on 16x6.5" Wheel
PCD: 5x114.3
Center Bore: 66.1 mm
🛡️ Technical Benefits for 2016 Nissan Qashqai
⛷️ Higher Ground Pressure
A narrower tire (205mm vs 215mm) concentrates vehicle weight onto a tighter contact patch, cutting cleanly through packed snow and slush down to asphalt.
🕳️ Pothole Damage Protection
The taller aspect ratio (+5% sidewall) creates an air buffer that prevents cracked alloy barrels on frost-damaged winter roads.
Brake Caliper Clearance: Verified OEM Rotor FitCompare Side-by-Side ⚡

📡 TPMS Protocol & Relearn Procedure

US OEM Sensor Protocol & Step-by-Step Calibration

DIRECT TPMS433 MHz
Architecture
Direct Valve Stem Transducer
Sensor Part Number
40700-4CB0B
Relearn Protocol
Auto-Relearn
Relearn Sequence0 / 3 Steps Complete
1
Inflate tires to recommended cold placard pressure.
2
Drive vehicle above 16 mph (25 km/h) continuously for 10-15 minutes.
3
The vehicle BCM (Body Control Module) will automatically register new sensor IDs and display individual tire pressures in instrument cluster.
TPMS warning light won't turn off after tire rotation?Find OBD2 TPMS Activation Tools on Amazon →

🔍 Pre-Purchase Fitment & Chassis Inspection Checklist

Universal 8-Point Buyer Guide →

✓ Wheel Hub & Bearing Inspection

  • • Check 66.1mm center hub spigot for rust scale; use wire brush before fitting alloy wheels.
  • • Verify wheel bearing hub play at 12 and 6 o'clock on service lift.

✓ Suspension & Steering Clearance

  • • Inspect front strut body clearance when fitting wheels wider than 8.0 inches.
  • • Check rear multi-link (AWD) or twist-beam (FWD) suspension bushings for wear.
Brake Caliper Clearance Note

Front single-piston floating calipers clear all factory 17, 18, and 19-inch wheels with generous radial clearance.

Common Wear Replacement Parts

📋 One-Click Forum Spec Exporter

Export verified specs for enthusiast forums (vBulletin, XenForo, Reddit).

🔩

Verified Hardware & Installation Kit for 2016 Qashqai

DIRECT OEM SPEC MATCH
🛡️Owner Crowd Verification(84% Verified)
Verified Fitment & Engineering FAQ

Frequently Asked Questions (2016 Nissan Qashqai)

8 Verified Q&As
Q What is the bolt pattern for a 2016 Nissan Qashqai?
The factory bolt pattern (PCD) for the 2016 Nissan Qashqai is 5x114.3 (5-lug configuration) with a pitch circle diameter of 114.3 mm. Center bore hub diameter is 66.1 mm.
Q What is the wheel lug torque specification for a 2016 Nissan Qashqai?
The official factory wheel lug torque specification for the 2016 Nissan Qashqai is 83 ft-lbs (113 Nm). Tighten all Lug Nuts in a criss-cross (star) sequence in two progressive stages using a calibrated torque wrench. Re-torque after 50 to 100 miles.
Q What is the towing capacity of a 2016 Nissan Qashqai?
The official maximum braked towing capacity for the 2016 Nissan Qashqai is 3,968 lbs (1,800 kg) with a maximum tongue weight limit of 397 lbs. Recommended hitch receiver: Class III (2-inch Receiver). Unbraked trailer limit is 1,389 lbs.
Q What is the factory tire size and recommended cold tire pressure (PSI) for a 2016 Nissan Qashqai?
Factory stock tire sizing for the 2016 Nissan Qashqai is 215/60R17 with a recommended cold tire pressure of 33 PSI front and 30 PSI rear. Always verify exact trim cold inflation pressure on the driver door-jamb FMVSS safety placard.
Q What is the center bore size on a 2016 Nissan Qashqai and are hub centric rings needed?
The center bore diameter is exactly 66.1 mm. The hub is hub-centric, meaning wheels center precisely on the axle spigot. If installing aftermarket wheels with a larger center bore (e.g., 73.1mm), precision hub centric centering rings (73.1mm to 66.1mm) are required to eliminate high-speed steering wheel vibrations.
Q What size lug nuts and thread pitch does a 2016 Nissan Qashqai use?
The 2016 Nissan Qashqai utilizes M12x1.25 Lug Nuts with a Conical 60deg seating profile. Never mix conical aftermarket wheels with OEM ball-seat fasteners or vice-versa, as mismatched seating angles cause fastener loosening.
Q Does the 2016 Nissan Qashqai have Direct or Indirect TPMS and how is it reset?
It features a Direct TPMS system utilizing physical valve-stem pressure sensors operating at 433 MHz. The relearn protocol is Auto-Relearn: Inflate tires to recommended cold placard pressure.
Q What aftermarket wheel offset and tire sizes fit a 2016 Nissan Qashqai without rubbing?
For an aggressive yet flush aesthetic without fender rolling or rubbing, the recommended setup is 18x8.0 ET38 wheels with 225/55R18 tires. For a 100% rub-free conservative upgrade, choose 17x7.5 ET38 with 215/60R17. Factory safe offset range spans +35mm to +45mm.

⚠️ Official NHTSA Safety Recalls & Bulletins

NHTSA #19V654000 • Back-Over Prevention: Camera Display

Nissan recalled certain Rogue Sport / Qashqai vehicles due to rear visibility system settings that allow backup camera display deactivation.

Remedy: Dealers update body control module software free of charge.