2026 Hyundai Ioniq 5 N
Wheel fitment, bolt pattern, TPMS calibration, and factory engineering specifications.
2026 Hyundai Ioniq 5 N Towing Capacity & Hitch Telemetry
Official manufacturer braked tow ratings, max tongue weight, and payload limits.
Hyundai officially rates the Ioniq 5 N at 0 lbs / 0 kg (Not Recommended for Towing) due to its rear aerodynamic diffuser, track-tuned thermal cooling architecture, and rear chassis bracing.
- โข Unbraked trailer maximum limit: 0 lbs (0 kg).
- โข Trailer brakes mandatory for loads exceeding 3,000 lbs in most jurisdictions.
- โข Maintain tongue weight between 10%โ15% of total gross trailer weight (GTW) to prevent dangerous trailer sway.
2026 Hyundai Ioniq 5 N Quick Fitment Answers
Looking for exact hub and wheel specifications for the 2026 Hyundai Ioniq 5 N? The factory bolt pattern is 5x114.3 (5-lug) with a 67.1 mm center bore. The manufacturer specified wheel lug torque is 137 ft-lbs (186 Nm) using M14x1.5 Lug Nuts with a Conical 60ยฐ seating surface. Safe wheel offset range is +35mm to +48mm.
Factory OEM Wheel & Tire Configurations (2026)
1 TRIM OPTIONS| Trim Name | Wheel Size | Tire Specification | Placard PSI | Equipment |
|---|---|---|---|---|
| N Performance (21" Forged Aluminum - Pirelli P Zero Elect HN) | 21x9.5 ET+45 | 275/35R21
Compare โก
| 36 / 39 PSI | Find Tires โ |
๐ง Technical Service Bulletins (TSB) & Suspension Chronic Issues
3 DOCUMENTED ISSUESDeformed 21mm OEM lug nut caps or incorrect M12 replacement nuts failing to thread
Unlike the standard Ioniq 5 (M12x1.5 @ 79โ94 lb-ft), the Ioniq 5 N uses upgraded M14x1.5 studs torqued to 18.0โ20.0 kgfยทm (130โ145 lb-ft) with two-piece 21mm flower-head nuts.
Sudden 12V battery discharge or 'Check Electric Vehicle System' warning
Overcurrent spikes during AC charging/DC-DC conversion stress ICCU MOSFETs on E-GMP platforms.
High-speed steering wheel or seat vibration above 65 mph
Inner PNCS sound-absorbing foam ring inside 275/35R21 tires can delaminate after hard track heat cycles or pothole impacts.
Hub Centric Ring Finder & Vibration Eliminator
Precision adapter sizing for Hyundai Ioniq 5 N factory 67.1 mm hub snout.
The wheel bore is +6.0 mm larger than the vehicle hub. To prevent steering wheel wobble at 50โ75 mph, install this exact ring set:
OEM vs. Aftermarket Visual Stance & Poke Gauge
Simulate fender lip clearance (Poke) and inner suspension strut clearance in real time.
Printable Mechanic Spec Card & Torque Sequence
High-contrast pocket card for tire shops, track days, and garage toolboxes.
2026 Hyundai Ioniq 5 N
fitmentspec.com/hyundai/ioniq-5-n/2026DIRECT HUB-CENTRIC WHEEL INTERCHANGE
Vehicles sharing both the exact 5x114.3 bolt pattern and 67.1 mm hub bore.
Cross-Vehicle OEM Wheel Swap Compatibility (5x114.3)
Verified OEM donor vehicles whose factory wheels fit the Hyundai Ioniq 5 N hub (67.1mm).

Alfa Romeo 8C Competizione

Ferrari 296 GTB

Ferrari 458 Italia

Ferrari 488 GTB

Ferrari 812 Superfast

Ferrari California

Ferrari F8 Tributo

Ferrari Purosangue
โก Will It Rub? 2D Offset & Strut Clearance
Real-time inner strut clearance and outer fender poke calculation.
WINTER WHEEL & MINUS-SIZING ADVISOR
Optimal cold-weather setup for maximum snow bite, pothole cushion, and rim protection.
๐ก TPMS Protocol & Relearn Procedure
US OEM Sensor Protocol & Step-by-Step Calibration
๐ Pre-Purchase Fitment & Chassis Inspection Checklist
Universal 8-Point Buyer Guide โโ Wheel Hub & Bearing Inspection
- โข Confirm M14x1.5 wheel studs are clean and unstretched; verify OEM lug torque is within Hyundai N spec (130โ145 lb-ft / 177โ196 Nm).
- โข Inspect OEM 21-inch forged wheels for curb rash or two-piece lug nut cap swelling from impact wrenches.
โ Suspension & Steering Clearance
- โข Inspect all four 275/35R21 Pirelli P Zero Elect (HN) tires for inner shoulder wear and PNCS acoustic foam separation vibration at highway speed.
- โข Check Electronic Controlled Suspension (ECS) dampers and e-LSD rear differential housing for fluid seepage or track-use heat discoloration.
Massive 400mm (15.7-inch) front rotors with 4-piston monobloc N calipers and 360mm rear rotors eliminate fitment of 18-inch and most 19-inch wheels; aftermarket 20-inch wheels must verify spoke/barrel clearance and M14 lug hole diameter.
๐ One-Click Forum Spec Exporter
Export verified specs for enthusiast forums (vBulletin, XenForo, Reddit).
Verified Hardware & Installation Kit for 2026 Ioniq 5 N
Frequently Asked Questions (2026 Hyundai Ioniq 5 N)
Q What is the bolt pattern for a 2026 Hyundai Ioniq 5 N?
Q What is the wheel lug torque specification for a 2026 Hyundai Ioniq 5 N?
Q What is the towing capacity of a 2026 Hyundai Ioniq 5 N?
Q What is the factory tire size and recommended cold tire pressure (PSI) for a 2026 Hyundai Ioniq 5 N?
Q What is the center bore size on a 2026 Hyundai Ioniq 5 N and are hub centric rings needed?
Q What size lug nuts and thread pitch does a 2026 Hyundai Ioniq 5 N use?
Q Does the 2026 Hyundai Ioniq 5 N have Direct or Indirect TPMS and how is it reset?
Q What aftermarket wheel offset and tire sizes fit a 2026 Hyundai Ioniq 5 N without rubbing?
โ ๏ธ Official NHTSA Safety Recalls & Bulletins
Hyundai Recall 277 (superseding Recall 275 / updated under 26V068000): Integrated Electronic Brake (IEB) and Vehicle Control Unit (VCU) software logic defect when Left-Foot Braking (LFB) or N e-Shift is active on certain 2025 Ioniq 5 N vehicles.
E-GMP Integrated Charging Control Unit (ICCU) thermal/overcurrent stress can damage internal LDC transistors and fuse, preventing 12V auxiliary battery charging.