FitmentSpec Logo
Jeep logo
4th Gen (JL) (2018–2026)

2024 Jeep Wrangler

Wheel fitment, bolt pattern, TPMS calibration, and factory engineering specifications.

2024 Jeep Wrangler
Factory Powertrain 3.6L Pentastar V6 with eTorque
285 HP (213 kW) 260 lb-ft 3.6L V6
Chassis Dimensions Exterior & Curb Weight
L: 188.4" W: 73.8" WB: 118.4" 4,167 – 4,449 lbs lbs
Bolt Pattern5-Lug
5x127
Center BoreHub Centric
71.5 mm
Hub Ring Spigot Diameter
Offset RangeET
-12 to +45
Flush Target: ET +-18
Lug TorqueM14x1.5
130 ft-lbs
176 Nm • Conical Seat
Fastener: Conical 60° Lug Nut. Always re-torque after 50–100 miles of driving.Get Torque Wrench→
⚠️
Mandatory Verification Notice: Bolt patterns, hub tolerances, and torque values vary by factory brake option and trim. Always verify specs with your vehicle's driver door-jamb safety placard or a certified mechanic prior to mounting wheels. Use of this data is strictly at your own risk. Read Full Legal Disclaimer →
⚓

2024 Jeep Wrangler Towing Capacity & Hitch Telemetry

Official manufacturer braked tow ratings, max tongue weight, and payload limits.

Certified Tow Rating: 5,000 lbs
Max Towing (Braked)
5,000 lbs
2,268 kg
With factory trailer brakes
Max Payload Capacity
1,351 lbs
613 kg
Cabin + bed passenger load
Max Tongue Weight (10%)
500 lbs
227 kg
Maximum hitch downward load
Hitch Receiver Class
Class II/III (2-inch Receiver)
Standard bumper / ball mount
🚛 Can It Tow? Real-World Trailer Capability Matcher
Click any trailer type to test compatibility against 2024 Wrangler
Selected Load: 5,000 lbs • Vehicle Rating: 5,000 lbs
At Maximum Limit (Caution)
📋 Factory Towing Guidance:

2024+ 4-door Rubicon with full-float Dana 44 HD rear axle rated up to 5,000 lbs; other 4-door models rated at 3,500 lbs; 2-door models rated at 2,000 lbs.

⚙️ Essential Towing Safety Guidelines:
  • • Unbraked trailer maximum limit: 1500 lbs (680 kg).
  • • Trailer brakes mandatory for loads exceeding 3,000 lbs in most jurisdictions.
  • • Maintain tongue weight between 10%–15% of total gross trailer weight (GTW) to prevent dangerous trailer sway.

2024 Jeep Wrangler Quick Fitment Answers

Looking for exact hub and wheel specifications for the 2024 Jeep Wrangler? The factory bolt pattern is 5x127 (5-lug) with a 71.5 mm center bore. The manufacturer specified wheel lug torque is 130 ft-lbs (176 Nm) using M14x1.5 Lug Nuts with a Conical 60° seating surface. Safe wheel offset range is +-12mm to +45mm.

Factory OEM Wheel & Tire Configurations (2024)

2 TRIM OPTIONS
Trim Name Wheel Size Tire Specification Placard PSI Equipment
Sport / Sahara 17x7.5 ET+44.4
245/75R17 Compare ⚡
36 / 36 PSI Find Tires →
Rubicon High-Clearance 17x7.5 ET+44.4
285/70R17 Compare ⚡
37 / 37 PSI Find Tires →

🔧 Technical Service Bulletins (TSB) & Suspension Chronic Issues

1 DOCUMENTED ISSUES
Steering & Solid Front Axle Critical Severity
Symptom

Violent steering wheel oscillation ('Death Wobble') after hitting highway bumps or bridge joints

Root Cause & TSB Details

TSB for track bar bracket play, steering damper aeration, and loose drag link joints

Affected Components: Front Track BarSteering DamperDrag Link Tie Rod
⭕

Hub Centric Ring Finder & Vibration Eliminator

Precision adapter sizing for Jeep Wrangler factory 71.5 mm hub snout.

Factory Hub: 71.5mm
Hub Diagnostic Result
✅ HUB CENTRIC RINGS REQUIRED

The wheel bore is +1.6 mm larger than the vehicle hub. To prevent steering wheel wobble at 50–75 mph, install this exact ring set:

73.1mm to 71.5mm (OD: 73.1mm / ID: 71.5mm)
🛒 Order 73.1mm to 71.5mm Ring Set on Amazon↗
💡 Pro Tip: Aluminum billet rings are recommended for track / high brake heat; polycarbonate plastic rings are ideal for salt & winter weather.
📐

OEM vs. Aftermarket Visual Stance & Poke Gauge

Simulate fender lip clearance (Poke) and inner suspension strut clearance in real time.

Stock Baseline: 7.5" ET44.4
New Wheel Width:8.5" (+1.0" vs OEM)
New Wheel Offset (ET):ET34.4 mm (-10mm vs OEM)
Wheel Spacer (Optional):+0 mm
Stance & Clearance Breakdown🔥 WIDE POKE
Outer Lip (Fender Poke)
+22.7mm
Extends outward toward fender
Inner Lip (Strut Room)
-2.7mm
Closer to suspension strut
FENDER LIPHUB FACE
Inner Strut SideOuter Wheel Face
📋

Printable Mechanic Spec Card & Torque Sequence

High-contrast pocket card for tire shops, track days, and garage toolboxes.

5x127
2018-2026 FITMENT SPECIFICATION

2024 Jeep Wrangler

fitmentspec.com/jeep/wrangler/2024
FINAL TORQUE130 ft-lbs(176 Nm)
Bolt Pattern (PCD)5x127
Center Bore71.5 mm
Fastener & ThreadM14x1.5Lug Nut • Conical 60°
TPMS CalibrationDirectDoor Placard PSI
⭐ TORQUE SEQUENCE:Always torque in a star (criss-cross) pattern in 2 stages: 50% initial hand snug, 100% with calibrated torque wrench.
⚠️ NEVER USE IMPACT GUN FOR FINAL TORQUE
🔄

DIRECT HUB-CENTRIC WHEEL INTERCHANGE

Vehicles sharing both the exact 5x127 bolt pattern and 71.5 mm hub bore.

✓ No Centering Rings Required
2017-202671.5 mm CB
Chrysler Pacifica
Torque: 130 ft-lbsSpecs →
2011-202671.5 mm CB
Dodge Durango
Torque: 130 ft-lbsSpecs →
2018-202671.5 mm CB
Dodge Durango
Torque: 130 ft-lbsSpecs →
2020-202671.5 mm CB
Jeep Gladiator
Torque: 130 ft-lbsSpecs →
2021-202671.5 mm CB
Jeep Grand Cherokee
Torque: 130 ft-lbsSpecs →
2021-202671.5 mm CB
Jeep Grand Cherokee L
Torque: 130 ft-lbsSpecs →

⚡ Will It Rub? 2D Offset & Strut Clearance

Real-time inner strut clearance and outer fender poke calculation.

CAUTION: Tight clearance. May contact fender under full suspension travel.
OEM Baseline18x8 ET+50
Rim Width: 8"Offset: +50mm
Target Custom Spec18x8.5 ET+40
Rim Width: 8.5"Offset: +40mm
Inner Strut Shift
-3.7 mm
More inner room
Fender Poke Shift
+16.3 mm
Extends outward
▲ Significant DifferenceDiameter: +1.24" (+3.94%)
+3.94%
Original Baseline Tire245/75R17
New Target Tire285/70R17
QUICK SIZES:
31.5"32.7"
Speedometer Variance Table
30 mph gauge31.2 actual+1.2 mph
45 mph gauge46.8 actual+1.8 mph
60 mph gauge62.4 actual+2.4 mph
70 mph gauge72.8 actual+2.8 mph
80 mph gauge83.2 actual+3.2 mph
❄️

WINTER WHEEL & MINUS-SIZING ADVISOR

Optimal cold-weather setup for maximum snow bite, pothole cushion, and rim protection.

OPTIMAL WINTER SPEC
235/80R16
Mounted on 16x6.5" Wheel
PCD: 5x127
Center Bore: 71.5 mm
🛡️ Technical Benefits for 2024 Jeep Wrangler
⛷️ Higher Ground Pressure
A narrower tire (235mm vs 245mm) concentrates vehicle weight onto a tighter contact patch, cutting cleanly through packed snow and slush down to asphalt.
🕳️ Pothole Damage Protection
The taller aspect ratio (+5% sidewall) creates an air buffer that prevents cracked alloy barrels on frost-damaged winter roads.
Brake Caliper Clearance: Verified OEM Rotor FitCompare Side-by-Side ⚡

📡 TPMS Protocol & Relearn Procedure

US OEM Sensor Protocol & Step-by-Step Calibration

DIRECT TPMS433 MHz
Architecture
Direct Valve Stem Transducer
Sensor Part Number
Mopar 68339096AB
Relearn Protocol
Auto-Relearn
Relearn Sequence0 / 3 Steps Complete
1
Adjust all five tires (including spare mounted on tailgate) to 36-37 PSI.
2
Drive vehicle for 10-15 minutes at continuous speeds above 15 mph.
3
The wireless receiver will automatically register new sensor IDs into the instrument cluster.
TPMS warning light won't turn off after tire rotation?Find OBD2 TPMS Activation Tools on Amazon →

🔍 Pre-Purchase Fitment & Chassis Inspection Checklist

Universal 8-Point Buyer Guide →

✓ Wheel Hub & Bearing Inspection

  • • Check unit bearing hub assemblies for looseness or moisture intrusion after off-road water crossings.
  • • Verify factory M14x1.5 lug nuts are properly torqued to 130 ft-lbs (many tire shops under-torque).

✓ Suspension & Steering Clearance

  • • Inspect front track bar and drag link ball joints for play.
  • • Check rear spare tire carrier clearance with oversized 35-inch tires.
Brake Caliper Clearance Note

17-inch wheels are standard; 15-inch and 16-inch wheels will not clear the heavy-duty JL brake calipers.

Common Wear Replacement Parts

📋 One-Click Forum Spec Exporter

Export verified specs for enthusiast forums (vBulletin, XenForo, Reddit).

🔩

Verified Hardware & Installation Kit for 2024 Wrangler

DIRECT OEM SPEC MATCH
🛡️Owner Crowd Verification(84% Verified)
Verified Fitment & Engineering FAQ

Frequently Asked Questions (2024 Jeep Wrangler)

8 Verified Q&As
Q What is the bolt pattern for a 2024 Jeep Wrangler?
The factory bolt pattern (PCD) for the 2024 Jeep Wrangler is 5x127 (5-lug configuration) with a pitch circle diameter of 127 mm. Center bore hub diameter is 71.5 mm.
Q What is the wheel lug torque specification for a 2024 Jeep Wrangler?
The official factory wheel lug torque specification for the 2024 Jeep Wrangler is 130 ft-lbs (176 Nm). Tighten all Lug Nuts in a criss-cross (star) sequence in two progressive stages using a calibrated torque wrench. Re-torque after 50 to 100 miles.
Q What is the towing capacity of a 2024 Jeep Wrangler?
The official maximum braked towing capacity for the 2024 Jeep Wrangler is 5,000 lbs (2,268 kg) with a maximum tongue weight limit of 500 lbs. Recommended hitch receiver: Class II/III (2-inch Receiver). Unbraked trailer limit is 1,500 lbs.
Q What is the factory tire size and recommended cold tire pressure (PSI) for a 2024 Jeep Wrangler?
Factory stock tire sizing for the 2024 Jeep Wrangler is 245/75R17 with a recommended cold tire pressure of 36 PSI front and 36 PSI rear. Always verify exact trim cold inflation pressure on the driver door-jamb FMVSS safety placard.
Q What is the center bore size on a 2024 Jeep Wrangler and are hub centric rings needed?
The center bore diameter is exactly 71.5 mm. The hub is hub-centric, meaning wheels center precisely on the axle spigot. If installing aftermarket wheels with a larger center bore (e.g., 73.1mm), precision hub centric centering rings (73.1mm to 71.5mm) are required to eliminate high-speed steering wheel vibrations.
Q What size lug nuts and thread pitch does a 2024 Jeep Wrangler use?
The 2024 Jeep Wrangler utilizes M14x1.5 Lug Nuts with a Conical 60° seating profile. Never mix conical aftermarket wheels with OEM ball-seat fasteners or vice-versa, as mismatched seating angles cause fastener loosening.
Q Does the 2024 Jeep Wrangler have Direct or Indirect TPMS and how is it reset?
It features a Direct TPMS system utilizing physical valve-stem pressure sensors operating at 433 MHz. The relearn protocol is Auto-Relearn: Adjust all five tires (including spare mounted on tailgate) to 36-37 PSI.
Q What aftermarket wheel offset and tire sizes fit a 2024 Jeep Wrangler without rubbing?
For an aggressive yet flush aesthetic without fender rolling or rubbing, the recommended setup is 17x9.0 ET-6 wheels with 315/70R17 (35-inch) tires. For a 100% rub-free conservative upgrade, choose 17x8.5 ET10 with 285/70R17 (33-inch). Factory safe offset range spans +-12mm to +45mm.