FitmentSpec Logo
Factory Powertrain 4.0L 1GR-FE V6 Dual VVT-i
270 HP (201 kW) 278 lb-ft 4.0L V6
Chassis Dimensions Exterior & Curb Weight
L: 190.2" W: 75.8" WB: 109.8" 4,400 – 4,805 lbs lbs
Center BoreHub Centric
106.1 mm
Hub Ring Spigot Diameter
Offset RangeET
-10 to +30
Flush Target: ET +-12
Lug TorqueM12x1.5
83 ft-lbs
112 Nm • Conical Seat
Fastener: Conical 60° (Aftermarket) / Mag Flat (OEM) Lug Nut. Always re-torque after 50–100 miles of driving.Get Torque Wrench→
⚠️
Mandatory Verification Notice: Bolt patterns, hub tolerances, and torque values vary by factory brake option and trim. Always verify specs with your vehicle's driver door-jamb safety placard or a certified mechanic prior to mounting wheels. Use of this data is strictly at your own risk. Read Full Legal Disclaimer →
⚓

2017 Toyota 4Runner Towing Capacity & Hitch Telemetry

Official manufacturer braked tow ratings, max tongue weight, and payload limits.

Certified Tow Rating: 5,000 lbs
Max Towing (Braked)
5,000 lbs
2,268 kg
With factory trailer brakes
Max Payload Capacity
1,700 lbs
771 kg
Cabin + bed passenger load
Max Tongue Weight (10%)
500 lbs
227 kg
Maximum hitch downward load
Hitch Receiver Class
Class III (Integrated Receiver)
Standard bumper / ball mount
🚛 Can It Tow? Real-World Trailer Capability Matcher
Click any trailer type to test compatibility against 2017 4Runner
Selected Load: 5,000 lbs • Vehicle Rating: 5,000 lbs
At Maximum Limit (Caution)
📋 Factory Towing Guidance:

Body-on-frame platform with integrated tow hitch rated at 5,000 lbs (or 6,000 lbs on 6th-gen i-FORCE MAX hybrid).

⚙️ Essential Towing Safety Guidelines:
  • • Unbraked trailer maximum limit: 1500 lbs (680 kg).
  • • Trailer brakes mandatory for loads exceeding 3,000 lbs in most jurisdictions.
  • • Maintain tongue weight between 10%–15% of total gross trailer weight (GTW) to prevent dangerous trailer sway.

2017 Toyota 4Runner Quick Fitment Answers

Looking for exact hub and wheel specifications for the 2017 Toyota 4Runner? The factory bolt pattern is 6x139.7 (6-lug) with a 106.1 mm center bore. The manufacturer specified wheel lug torque is 83 ft-lbs (112 Nm) using M12x1.5 Lug Nuts with a Conical 60° (Aftermarket) / Mag Flat (OEM) seating surface. Safe wheel offset range is +-10mm to +30mm.

Factory OEM Wheel & Tire Configurations (2017)

2 TRIM OPTIONS
Trim Name Wheel Size Tire Specification Placard PSI Equipment
SR5 / Trail / TRD Off-Road 17x7.5 ET+15
265/70R17 Compare ⚡
32 / 32 PSI Find Tires →
Limited / Nightshade 20x7 ET+15
245/60R20 Compare ⚡
32 / 32 PSI Find Tires →

🔧 Technical Service Bulletins (TSB) & Suspension Chronic Issues

1 DOCUMENTED ISSUES
Steering & Front Suspension Moderate Severity
Symptom

Steering wheel vibration specifically between 58 and 62 mph

Root Cause & TSB Details

Needle bearing wear in driver side front differential tube; replaced with solid ECGS bushing

Affected Components: Front Differential Needle BearingCV Axle StubFront Hub
⭕

Hub Centric Ring Finder & Vibration Eliminator

Precision adapter sizing for Toyota 4Runner factory 106.1 mm hub snout.

Factory Hub: 106.1mm
Hub Diagnostic Result
🚨 INCOMPATIBLE WHEEL BORE (TOO SMALL)

The wheel bore (73.1 mm) is smaller than the car hub (106.1 mm). The wheel will NOT physically seat flush on the hub face without wheel spacers or center-bore machining.

💡 Pro Tip: Aluminum billet rings are recommended for track / high brake heat; polycarbonate plastic rings are ideal for salt & winter weather.
📐

OEM vs. Aftermarket Visual Stance & Poke Gauge

Simulate fender lip clearance (Poke) and inner suspension strut clearance in real time.

Stock Baseline: 7.5" ET15
New Wheel Width:8.5" (+1.0" vs OEM)
New Wheel Offset (ET):ET5 mm (-10mm vs OEM)
Wheel Spacer (Optional):+0 mm
Stance & Clearance Breakdown🔥 WIDE POKE
Outer Lip (Fender Poke)
+22.7mm
Extends outward toward fender
Inner Lip (Strut Room)
-2.7mm
Closer to suspension strut
FENDER LIPHUB FACE
Inner Strut SideOuter Wheel Face
📋

Printable Mechanic Spec Card & Torque Sequence

High-contrast pocket card for tire shops, track days, and garage toolboxes.

6x139.7
2010-2024 FITMENT SPECIFICATION

2017 Toyota 4Runner

fitmentspec.com/toyota/4runner/2017
FINAL TORQUE83 ft-lbs(112 Nm)
Bolt Pattern (PCD)6x139.7
Center Bore106.1 mm
Fastener & ThreadM12x1.5Lug Nut • Conical 60° (Aftermarket) / Mag Flat (OEM)
TPMS CalibrationDirectDoor Placard PSI
⭐ TORQUE SEQUENCE:Always torque in a star (criss-cross) pattern in 2 stages: 50% initial hand snug, 100% with calibrated torque wrench.
⚠️ NEVER USE IMPACT GUN FOR FINAL TORQUE

⚡ Will It Rub? 2D Offset & Strut Clearance

Real-time inner strut clearance and outer fender poke calculation.

CAUTION: Tight clearance. May contact fender under full suspension travel.
OEM Baseline18x8 ET+50
Rim Width: 8"Offset: +50mm
Target Custom Spec18x8.5 ET+40
Rim Width: 8.5"Offset: +40mm
Inner Strut Shift
-3.7 mm
More inner room
Fender Poke Shift
+16.3 mm
Extends outward
▲ Significant DifferenceDiameter: +1.10" (+3.49%)
+3.49%
Original Baseline Tire265/70R17
New Target Tire285/70R17
QUICK SIZES:
31.6"32.7"
Speedometer Variance Table
30 mph gauge31.0 actual+1.0 mph
45 mph gauge46.6 actual+1.6 mph
60 mph gauge62.1 actual+2.1 mph
70 mph gauge72.4 actual+2.4 mph
80 mph gauge82.8 actual+2.8 mph
❄️

WINTER WHEEL & MINUS-SIZING ADVISOR

Optimal cold-weather setup for maximum snow bite, pothole cushion, and rim protection.

OPTIMAL WINTER SPEC
255/75R16
Mounted on 16x6.5" Wheel
PCD: 6x139.7
Center Bore: 106.1 mm
🛡️ Technical Benefits for 2017 Toyota 4Runner
⛷️ Higher Ground Pressure
A narrower tire (255mm vs 265mm) concentrates vehicle weight onto a tighter contact patch, cutting cleanly through packed snow and slush down to asphalt.
🕳️ Pothole Damage Protection
The taller aspect ratio (+5% sidewall) creates an air buffer that prevents cracked alloy barrels on frost-damaged winter roads.
Brake Caliper Clearance: Verified OEM Rotor FitCompare Side-by-Side ⚡

📡 TPMS Protocol & Relearn Procedure

US OEM Sensor Protocol & Step-by-Step Calibration

DIRECT TPMS315 MHz
Architecture
Direct Valve Stem Transducer
Sensor Part Number
Toyota 42607-33021
Relearn Protocol
Cluster-Reset
Relearn Sequence0 / 5 Steps Complete
1
Set cold tire pressure to 32 PSI across all 4 tires plus spare tire if equipped with sensor.
2
Turn ignition to ON position.
3
Locate TPMS reset button below steering column on lower dash.
4
Press and hold TPMS reset button until warning light flashes 3 times slowly.
5
Drive for 20 minutes above 20 mph to complete sensor recognition.
TPMS warning light won't turn off after tire rotation?Find OBD2 TPMS Activation Tools on Amazon →

🔍 Pre-Purchase Fitment & Chassis Inspection Checklist

Universal 8-Point Buyer Guide →

✓ Wheel Hub & Bearing Inspection

  • • Inspect front wheel bearings for play or hum during 45-60 mph highway driving.
  • • Verify driver side CV axle stub has no excessive vertical radial play at diff output.

✓ Suspension & Steering Clearance

  • • Inspect front sway bar end links and KDSS hydraulic cylinder boots if equipped.
  • • Inspect factory upper control arm ball joints for grease weeping.
Brake Caliper Clearance Note

Factory front 4-piston calipers require minimum 17-inch wheels. Certain aftermarket 17-inch wheels with high backspacing may touch caliper face.

Common Wear Replacement Parts

📋 One-Click Forum Spec Exporter

Export verified specs for enthusiast forums (vBulletin, XenForo, Reddit).

🔩

Verified Hardware & Installation Kit for 2017 4Runner

DIRECT OEM SPEC MATCH
🛡️Owner Crowd Verification(84% Verified)
Verified Fitment & Engineering FAQ

Frequently Asked Questions (2017 Toyota 4Runner)

8 Verified Q&As
Q What is the bolt pattern for a 2017 Toyota 4Runner?
The factory bolt pattern (PCD) for the 2017 Toyota 4Runner is 6x139.7 (6-lug configuration) with a pitch circle diameter of 139.7 mm. Center bore hub diameter is 106.1 mm.
Q What is the wheel lug torque specification for a 2017 Toyota 4Runner?
The official factory wheel lug torque specification for the 2017 Toyota 4Runner is 83 ft-lbs (112 Nm). Tighten all Lug Nuts in a criss-cross (star) sequence in two progressive stages using a calibrated torque wrench. Re-torque after 50 to 100 miles.
Q What is the towing capacity of a 2017 Toyota 4Runner?
The official maximum braked towing capacity for the 2017 Toyota 4Runner is 5,000 lbs (2,268 kg) with a maximum tongue weight limit of 500 lbs. Recommended hitch receiver: Class III (Integrated Receiver). Unbraked trailer limit is 1,500 lbs.
Q What is the factory tire size and recommended cold tire pressure (PSI) for a 2017 Toyota 4Runner?
Factory stock tire sizing for the 2017 Toyota 4Runner is 265/70R17 with a recommended cold tire pressure of 32 PSI front and 32 PSI rear. Always verify exact trim cold inflation pressure on the driver door-jamb FMVSS safety placard.
Q What is the center bore size on a 2017 Toyota 4Runner and are hub centric rings needed?
The center bore diameter is exactly 106.1 mm. The hub is hub-centric, meaning wheels center precisely on the axle spigot. If installing aftermarket wheels with a larger center bore (e.g., 73.1mm), precision hub centric centering rings (73.1mm to 106.1mm) are required to eliminate high-speed steering wheel vibrations.
Q What size lug nuts and thread pitch does a 2017 Toyota 4Runner use?
The 2017 Toyota 4Runner utilizes M12x1.5 Lug Nuts with a Conical 60° (Aftermarket) / Mag Flat (OEM) seating profile. Never mix conical aftermarket wheels with OEM ball-seat fasteners or vice-versa, as mismatched seating angles cause fastener loosening.
Q Does the 2017 Toyota 4Runner have Direct or Indirect TPMS and how is it reset?
It features a Direct TPMS system utilizing physical valve-stem pressure sensors operating at 315 MHz. The relearn protocol is Cluster-Reset: Set cold tire pressure to 32 PSI across all 4 tires plus spare tire if equipped with sensor.
Q What aftermarket wheel offset and tire sizes fit a 2017 Toyota 4Runner without rubbing?
For an aggressive yet flush aesthetic without fender rolling or rubbing, the recommended setup is 17x8.5 ET-10 wheels with 275/70R17 tires. For a 100% rub-free conservative upgrade, choose 17x8.0 ET0 with 265/70R17. Factory safe offset range spans +-10mm to +30mm.