FitmentSpec Logo
Toyota logo
4th Gen (N400) (2024–2026)

2024 Toyota Tacoma

Wheel fitment, bolt pattern, TPMS calibration, and factory engineering specifications.

2024 Toyota Tacoma
Factory Powertrain 2.4L i-FORCE Turbocharged I4
278 HP (207 kW) 317 lb-ft 2.4L Inline-4
Chassis Dimensions Exterior & Curb Weight
L: 213" W: 76.9" WB: 131.9" 4,145 – 4,700 lbs lbs
Center BoreHub Centric
95.1 mm
Hub Ring Spigot Diameter
Offset RangeET
+25 to +55
Flush Target: ET +0
Lug TorqueM14x1.5
97 ft-lbs
131 Nm • Conical Seat
Fastener: Conical 60° (Aftermarket) / Mag with Flat Washer (OEM) Lug Nut. Always re-torque after 50–100 miles of driving.Get Torque Wrench→
⚠️
Mandatory Verification Notice: Bolt patterns, hub tolerances, and torque values vary by factory brake option and trim. Always verify specs with your vehicle's driver door-jamb safety placard or a certified mechanic prior to mounting wheels. Use of this data is strictly at your own risk. Read Full Legal Disclaimer →
⚓

2024 Toyota Tacoma Towing Capacity & Hitch Telemetry

Official manufacturer braked tow ratings, max tongue weight, and payload limits.

Certified Tow Rating: 6,800 lbs
Max Towing (Braked)
6,800 lbs
3,084 kg
With factory trailer brakes
Max Payload Capacity
1,709 lbs
775 kg
Cabin + bed passenger load
Max Tongue Weight (10%)
680 lbs
308 kg
Maximum hitch downward load
Hitch Receiver Class
Class III (2-inch Receiver)
Weight distribution rated
🚛 Can It Tow? Real-World Trailer Capability Matcher
Click any trailer type to test compatibility against 2024 Tacoma
Selected Load: 6,800 lbs • Vehicle Rating: 6,800 lbs
At Maximum Limit (Caution)
📋 Factory Towing Guidance:

Rated up to 6,800 lbs with 2.4L i-FORCE Turbo and factory tow package (Class III hitch, engine oil cooler, 7-pin wiring harness).

⚙️ Essential Towing Safety Guidelines:
  • • Unbraked trailer maximum limit: 1500 lbs (680 kg).
  • • Trailer brakes mandatory for loads exceeding 3,000 lbs in most jurisdictions.
  • • Maintain tongue weight between 10%–15% of total gross trailer weight (GTW) to prevent dangerous trailer sway.

2024 Toyota Tacoma Quick Fitment Answers

Looking for exact hub and wheel specifications for the 2024 Toyota Tacoma? The factory bolt pattern is 6x139.7 (6-lug) with a 95.1 mm center bore. The manufacturer specified wheel lug torque is 97 ft-lbs (131 Nm) using M14x1.5 Lug Nuts with a Conical 60° (Aftermarket) / Mag with Flat Washer (OEM) seating surface. Safe wheel offset range is +25mm to +55mm.

Factory OEM Wheel & Tire Configurations (2024)

2 TRIM OPTIONS
Trim Name Wheel Size Tire Specification Placard PSI Equipment
SR / SR5 Standard 17x7.5 ET+50
245/70R17 Compare ⚡
32 / 32 PSI Find Tires →
TRD Off-Road / Sport 17x7.5 ET+45
265/70R17 Compare ⚡
35 / 35 PSI Find Tires →

🔧 Technical Service Bulletins (TSB) & Suspension Chronic Issues

2 DOCUMENTED ISSUES
Hub & Front Axle Moderate Severity
Symptom

High-speed highway steering wheel shimmy between 55-65 mph

Root Cause & TSB Details

Aftermarket wheels installed without hub-centric centering rings (lug-centric vibrations on 95.1mm hub)

Affected Components: Wheel Hub Centering BoreFront RotorsSteering Rack
Front Suspension / Cab Mount Low Severity
Symptom

Tire rubbing noise on front inner fender liner during full steering lock in reverse

Root Cause & TSB Details

Oversized 33-inch tire setups contacting factory cab mount and front mud flap bracket

Affected Components: Fender LinerCab Mount PlateSplash Guard
⭕

Hub Centric Ring Finder & Vibration Eliminator

Precision adapter sizing for Toyota Tacoma factory 95.1 mm hub snout.

Factory Hub: 95.1mm
Hub Diagnostic Result
🚨 INCOMPATIBLE WHEEL BORE (TOO SMALL)

The wheel bore (73.1 mm) is smaller than the car hub (95.1 mm). The wheel will NOT physically seat flush on the hub face without wheel spacers or center-bore machining.

💡 Pro Tip: Aluminum billet rings are recommended for track / high brake heat; polycarbonate plastic rings are ideal for salt & winter weather.
📐

OEM vs. Aftermarket Visual Stance & Poke Gauge

Simulate fender lip clearance (Poke) and inner suspension strut clearance in real time.

Stock Baseline: 7.5" ET50
New Wheel Width:8.5" (+1.0" vs OEM)
New Wheel Offset (ET):ET40 mm (-10mm vs OEM)
Wheel Spacer (Optional):+0 mm
Stance & Clearance Breakdown🔥 WIDE POKE
Outer Lip (Fender Poke)
+22.7mm
Extends outward toward fender
Inner Lip (Strut Room)
-2.7mm
Closer to suspension strut
FENDER LIPHUB FACE
Inner Strut SideOuter Wheel Face
📋

Printable Mechanic Spec Card & Torque Sequence

High-contrast pocket card for tire shops, track days, and garage toolboxes.

6x139.7
2024-2026 FITMENT SPECIFICATION

2024 Toyota Tacoma

fitmentspec.com/toyota/tacoma/2024
FINAL TORQUE97 ft-lbs(131 Nm)
Bolt Pattern (PCD)6x139.7
Center Bore95.1 mm
Fastener & ThreadM14x1.5Lug Nut • Conical 60° (Aftermarket) / Mag with Flat Washer (OEM)
TPMS CalibrationDirectDoor Placard PSI
⭐ TORQUE SEQUENCE:Always torque in a star (criss-cross) pattern in 2 stages: 50% initial hand snug, 100% with calibrated torque wrench.
⚠️ NEVER USE IMPACT GUN FOR FINAL TORQUE
🔄

DIRECT HUB-CENTRIC WHEEL INTERCHANGE

Vehicles sharing both the exact 6x139.7 bolt pattern and 95.1 mm hub bore.

✓ No Centering Rings Required
2024-202695.1 mm CB
Lexus GX
Torque: 97 ft-lbsSpecs →
2024-202695.1 mm CB
Lexus GX 550
Torque: 97 ft-lbsSpecs →
2022-202695.1 mm CB
Lexus LX
Torque: 97 ft-lbsSpecs →
2025-202695.1 mm CB
Toyota 4Runner
Torque: 97 ft-lbsSpecs →
2024-202695.1 mm CB
Toyota Land Cruiser
Torque: 97 ft-lbsSpecs →
2024-202695.1 mm CB
Toyota Land Cruiser 250
Torque: 97 ft-lbsSpecs →

⚡ Will It Rub? 2D Offset & Strut Clearance

Real-time inner strut clearance and outer fender poke calculation.

CAUTION: Tight clearance. May contact fender under full suspension travel.
OEM Baseline18x8 ET+50
Rim Width: 8"Offset: +50mm
Target Custom Spec18x8.5 ET+40
Rim Width: 8.5"Offset: +40mm
Inner Strut Shift
-3.7 mm
More inner room
Fender Poke Shift
+16.3 mm
Extends outward
▲ Recalibrate RequiredDiameter: +2.20" (+7.23%)
+7.23%
Original Baseline Tire245/70R17
New Target Tire285/70R17
QUICK SIZES:
30.5"32.7"
Speedometer Variance Table
30 mph gauge32.2 actual+2.2 mph
45 mph gauge48.3 actual+3.3 mph
60 mph gauge64.3 actual+4.3 mph
70 mph gauge75.1 actual+5.1 mph
80 mph gauge85.8 actual+5.8 mph
❄️

WINTER WHEEL & MINUS-SIZING ADVISOR

Optimal cold-weather setup for maximum snow bite, pothole cushion, and rim protection.

OPTIMAL WINTER SPEC
235/75R16
Mounted on 16x6.5" Wheel
PCD: 6x139.7
Center Bore: 95.1 mm
🛡️ Technical Benefits for 2024 Toyota Tacoma
⛷️ Higher Ground Pressure
A narrower tire (235mm vs 245mm) concentrates vehicle weight onto a tighter contact patch, cutting cleanly through packed snow and slush down to asphalt.
🕳️ Pothole Damage Protection
The taller aspect ratio (+5% sidewall) creates an air buffer that prevents cracked alloy barrels on frost-damaged winter roads.
Brake Caliper Clearance: Verified OEM Rotor FitCompare Side-by-Side ⚡

📡 TPMS Protocol & Relearn Procedure

US OEM Sensor Protocol & Step-by-Step Calibration

DIRECT TPMS315 MHz
Architecture
Direct Valve Stem Transducer
Sensor Part Number
Toyota 42607-06030
Relearn Protocol
Cluster-Reset
Relearn Sequence0 / 5 Steps Complete
1
Park vehicle safely and adjust all tires to cold placard pressure (32-35 PSI).
2
Turn ignition to ON (engine off).
3
Navigate multi-information cluster display to Settings > Vehicle Settings > TPMS.
4
Select 'Tire Pressure Reset' and hold until TPMS warning light blinks 3 times.
5
Drive vehicle at 25+ mph for 10-15 minutes to complete automatic ID registration.
TPMS warning light won't turn off after tire rotation?Find OBD2 TPMS Activation Tools on Amazon →

🔍 Pre-Purchase Fitment & Chassis Inspection Checklist

Universal 8-Point Buyer Guide →

✓ Wheel Hub & Bearing Inspection

  • • Jack front wheel off ground, check for play at 12 and 6 o'clock positions.
  • • Rotate wheel by hand to listen for growling or gravel-like bearing friction.

✓ Suspension & Steering Clearance

  • • Check front upper control arm (UCA) ball joint clearance to inside tire sidewall.
  • • Inspect front sway bar end links for torn rubber boots or play.
Brake Caliper Clearance Note

Factory twin-piston calipers require minimum 17-inch wheel diameter; most 16-inch wheels will contact brake caliper bridge.

Common Wear Replacement Parts

📋 One-Click Forum Spec Exporter

Export verified specs for enthusiast forums (vBulletin, XenForo, Reddit).

🔩

Verified Hardware & Installation Kit for 2024 Tacoma

DIRECT OEM SPEC MATCH
🛡️Owner Crowd Verification(84% Verified)
Verified Fitment & Engineering FAQ

Frequently Asked Questions (2024 Toyota Tacoma)

8 Verified Q&As
Q What is the bolt pattern for a 2024 Toyota Tacoma?
The factory bolt pattern (PCD) for the 2024 Toyota Tacoma is 6x139.7 (6-lug configuration) with a pitch circle diameter of 139.7 mm. Center bore hub diameter is 95.1 mm.
Q What is the wheel lug torque specification for a 2024 Toyota Tacoma?
The official factory wheel lug torque specification for the 2024 Toyota Tacoma is 97 ft-lbs (131 Nm). Tighten all Lug Nuts in a criss-cross (star) sequence in two progressive stages using a calibrated torque wrench. Re-torque after 50 to 100 miles.
Q What is the towing capacity of a 2024 Toyota Tacoma?
The official maximum braked towing capacity for the 2024 Toyota Tacoma is 6,800 lbs (3,084 kg) with a maximum tongue weight limit of 680 lbs. Recommended hitch receiver: Class III (2-inch Receiver). Unbraked trailer limit is 1,500 lbs.
Q What is the factory tire size and recommended cold tire pressure (PSI) for a 2024 Toyota Tacoma?
Factory stock tire sizing for the 2024 Toyota Tacoma is 245/70R17 with a recommended cold tire pressure of 32 PSI front and 32 PSI rear. Always verify exact trim cold inflation pressure on the driver door-jamb FMVSS safety placard.
Q What is the center bore size on a 2024 Toyota Tacoma and are hub centric rings needed?
The center bore diameter is exactly 95.1 mm. The hub is hub-centric, meaning wheels center precisely on the axle spigot. If installing aftermarket wheels with a larger center bore (e.g., 73.1mm), precision hub centric centering rings (73.1mm to 95.1mm) are required to eliminate high-speed steering wheel vibrations.
Q What size lug nuts and thread pitch does a 2024 Toyota Tacoma use?
The 2024 Toyota Tacoma utilizes M14x1.5 Lug Nuts with a Conical 60° (Aftermarket) / Mag with Flat Washer (OEM) seating profile. Never mix conical aftermarket wheels with OEM ball-seat fasteners or vice-versa, as mismatched seating angles cause fastener loosening.
Q Does the 2024 Toyota Tacoma have Direct or Indirect TPMS and how is it reset?
It features a Direct TPMS system utilizing physical valve-stem pressure sensors operating at 315 MHz. The relearn protocol is Cluster-Reset: Park vehicle safely and adjust all tires to cold placard pressure (32-35 PSI).
Q What aftermarket wheel offset and tire sizes fit a 2024 Toyota Tacoma without rubbing?
For an aggressive yet flush aesthetic without fender rolling or rubbing, the recommended setup is 17x8.5 ET25 wheels with 275/70R17 tires. For a 100% rub-free conservative upgrade, choose 17x8.0 ET35 with 265/70R17. Factory safe offset range spans +25mm to +55mm.